Boat detail

Chris White Designs Hammerhead

Back to category

Sail

51,172 $

Chris White Designs Hammerhead

Launched August 2000
Builder: Newbury Watercraft
Length overall: 34’ 0”
Length waterline: 32’ 8”
Beam overall: 23’
Draft: 2’ to 6’
Masthead clearance from LWL: 45’ 7”
Displacement: 4800 lbs.
Engine: Yanmar 2GM20 18 hp diesel, 18 gallon tank

Sail area:
Mainsail: 377 sq/ft
Jib: 230 sq/ft


Construction

Main hull and decks are epoxy/glass sandwich construction with western red cedar core on bottom of main hull and cabin tops and Core-Cell SAN foam core elsewhere. Floats are Core-Cell with marine ply/fiberglass decks. Crossbeams are Core-Cell with substantial carbon reinforcement, with glass covered foam fairings. Highly loaded areas of hull, beam structures, and deck are locally reinforced with carbon fiber. Each float with its crossbeams is demountable for transport or storage. Centerboard and
rudder are foam/glass with carbon fiber reinforcement. WEST system Pro-Set brand epoxy resin is used for lamination. All structural and finish materials are of high quality.

The builder is a life-long sailor with considerable experience as a professional in the marine trades as well as in sailboard building and repair.

Mast and rig:

The boat is rigged as a fractional sloop, with single spreaders for two sets of diamond stays, capshrouds and intermediates to the floats, and Vectran running backstays (used in strong conditions only). The mast is deck stepped and electrically grounded to the water. Painted Metalmast aluminum spars and substantial stainless wire standing rigging with Norseman terminals are utilized. Harken battcars and blocks simplify sailhandling and reefing. A topping lift and lazy jacks are rigged. Three reefs are available in the mainsail. Jib is provided with a Profurl furler. This rig provides ample options for power with ease of control under all points of sail. Speeds in the low teens are common.

Sails

All Sails 2000 by Quantum
Main: 377 sq. ft. Dacron/mylar cruise lam sailcloth, full length battens with Harken ball bearing Battcars,
lazy jacks, topping lift, and custom Sunbrella cover.
Jib: 230 sq. ft. Dacron/mylar cruise lam sailcloth on Profurl NC-32 furler, Sunbrella cover
Asymmetrical Spinnaker

Deck Hardware and Layout

All running rigging operated from the cockpit. (3) Lewmar #40AST self tailing sheet winches, (1)
Lewmar #32AST self tailing winch for main halyard/reefing lines, (2) Lewmar #16AST on coamings for spi and runners. Lewmar stoppers are provided for all
lines as appropriate.

Custom anodized aluminum bow pulpit on the foredeck reaches back to the forward beam. Aluminum stem and anchor roller fitting houses a 22 lb. Delta Anchor. Self balling anchor & rode deck locker holds anchor chain and 200 foot nylon rode with ample room left over for the anchor. Nets are coated knotless seine netting.

Cockpit and Steering

The cockpit is protected by a Sunbrella dodger (2002) with removable “back porch” cover for harbor use.
Steering is by a vertical aluminum whipstaff located in the aft cockpit bulkhead, allowing plenty of legroom. Engine panel and controls are conveniently located at the steering station. Steering by stainless steel wire to the Edson quadrant at the kick-up cassette rudder.

Ventilation and Heating

Four Lewmar deck hatches provide light and air to the forward cabin, head, and saloon, Two Vetus ventilators serve the aft cabin. A large Lewmar hatch is located in each float deck to access substantial stowage therein.

Tankage and Plumbing

Water tank is a +-28 gal. integral fiberglass/epoxy tank located next to centerboard case in the main cabin, filled at deck plates in the cabin floor. Fuel tank is an 18 gal Tempo plastic tank under aft bunk. Tanks are appropriately baffled and vented. Holding tank is approximately 11 gallons, and serves a Lavac vacuum pump toilet fixture. The tank will empty by gravity to the water or can be closed for later pumpout at the deck. All hoses and fittings are of top quality and all through hulls to the water are fitted with
Forespar Marelon ball valves.

Fresh water is fed to the galley sink by a small Flojet electrical pump.

Engine/Drivetrain

Diesel fuel is filtered by both a primary Racor filter/water separator and a secondary Yanmar fuel filter. A raw water intake strainer is installed, The freshwater cooled Yanmar 18 HP engine is equipped with a \"PSS\" shaft seal fitted to a 1\" Aquamet shaft which drives the Flex-o-fold geared folding propeller. Engine and drive components are easily accessed through large removable hatch in the cockpit floor and a panel under the main companionway.

Speed under power is in the 6-7.5 knot range at .4 gal./hr.

Electrical/Electronics

Two 85 amp hour 12-volt DC gel batteries are recharged by the engine alternator and feed a custom circuit breaker panel with amp load and battery voltage guages. Electrical requirements are well divided among 18 appropriately sized circuit breakers. Cabin, navigation, and deck lighting fixtures are well placed and of high quality with red night lighting is available in the nav area.

Nexus Multi instrumentation for speed and depth and Plastimo compass are installed alongside the companionway. A VHF radio with mast mounted antenna is in the nav station. A Standard 170C GPS/chartplotter and a Furuno 1622 radar are usable from the cockpit on swing-out mounts above the chart table. An Autohelm ST-1500 tiller autopilot is ready to take the helm.

Interior/Layout

The interior of the boat is off-white polyurethane paint, varnished mahogany, ash and corian countertops, teak and holly sole in main cabin, and attractive cushions of marine quality. Stowage spaces are well distributed, ample, handily arranged, and secure
throughout the boat.

From forward to aft the layout is as follows:

A stowage area forward of the head, and under the anchor locker on deck.

Head compartment with Lavac head.

A cabin with a single 6”6” bunk and stowage under.

The main cabin features two settees, 6\' 0\" and 5.0\" in length, one usable a bunk, with stowage under. A raised floor in between these settees houses the water tank, a 4 cu.ft. well-insulated icebox, and additional storage. Visibility out the many fixed lights in
the trunk cabin is excellent and two small ventilation hatches are in the overhead.

The galley is aft and to starboard with a deep stainless sink, a small counter area, and a 2-burner Force 10 propane stove with broiler. There are bins, shelves, and cabinets outboard and under the galley area.

Opposite the galley on the port side is the nav table with a lift top and stowage under. Electrical panel, VHF, and storage are outboard.

Aft of the cockpit is a cabin that is fitted out as a large double bunk with stowage under.

Miscellaneous Equipment:

Second anchor: 13 lb. Fortress anchor with 15\' chain, 200\' Nylon rode.
4 docking fenders and 6 dock lines.
Life Jackets
Standard required safety equipment
Sony CD/stereo

Price: US$129,000.


All particulars are believed to be correct, however some items may be listed in error. It remains the
responsibility of the buyer to verify that all listed equipment is onboard.

Features:

TypeSail

CategoryMulti-Hulls

MakeChris White Designs

ModelHammerhead

Year built2000

Length33.99ft

Hull MaterialComposite

New/UsedUsed