Back to the main page Back to category Cruisers

Boat details

Liberty Pacific Seacraft Cutter Rigged Canoe Stern

Estimated price for orientation: 80 637 $

Category: Cruisers
Class: Sail

Liberty Pacific Seacraft Cutter Rigged Canoe Stern - RARE BOAT BRISTOL CONDITION

'SEA JOY' - She is a LIBERTY - Built in Riviera Beach, Florida - HULL # 4 OF ONLY SIX WERE MADE - Truly overbuilt with the best of materials and craftsmanship !!!  A VERY RARE BOAT !! Full keel, Canoe stern bluewater cruising, cutter rigged sloop.  Only two owners - Present owners have owned her since 2001 - The ongoing maintenance has kept her in BRISTOL condition !! Truly a unique and beautiful boat that needs nothing.

Full cockpit - Bimini (2013) - Dodger (2011) - Connector - All around cockpit cushions (Closed cell foam) for comfort and dryness - Pedestal steering - Fold up / down table - Beautiful varnished teak coaming  surrounding cockpit. Custom teak grided platform in front of helm seat.

All chain plates are secured to the hullsides - Allowing wide, unobstructed, walk around decks.

Custom sun awnings - over the boom and over the foredeck -

Entire interior is all beautifully finished teak - beautiful color / joinery and varnished finish - Wonderful storage cabinets, drawers, hanging lockers throughout. Ten chromed opening ports with screens. Three opening hatches. Beautiful teak and holly sole

Enter a bright, spacious salon with 6'5" headroom -  settees on both sides - Centerline dining table with large fold up / down leafs - like new upholstery -  U shaped galley  to starboard - Forward facing navigation station to port. - Balmar 120 diesel cabin heater  on forward bulkhead - Marine Air reverse cycle air conditioning / heat - (Rebuilt in 2011) with digital controls.

Beautifully finished private head with built in storage - head - shower

Forward is the spacious master cabin with large V berths with filler cushion. Beautiful built in cabinets on both sides - Large, built in storage drawers and hanging closet in hallway from salon to master cabin.

Large, open U shaped galley with double stainless sink - Warner Dickerson Marine Regal stainless gimbaled, propane 3 burner stove with oven / broiler - Solenoid switch - Grunert 12 volt refrigeration system - deep cold box - with new compressor,  Hot and cold pressure water - GE microwave oven. Two 20 lb aluminum propane tanks in vented locker aft of the cockpit helm station. Hot water heater is 110V and looped through engine.

SAILS AND RIGGING:

Cutter rigged with Kenyon painted aluminum mast, boom and single spreaders - Keel stepped - Stainless rigging with double lowers, intermediate and baby stay. Four to one purchase main sheet with Lewmar traveler forward in the cockpit. Bronze genoa and inboard staysail tracks with cars and blocks.

Fully battened main with lazy jacks and sail cover - (New in 2009) - Geona (Approx 125 %) on Harken roller furler - Staysail on Harken roller furler.

Sail area 852 sq. ft. - SA/ disp ratio 162 - Disp / length ratio 322

Barient # 27 self tailing primary winches - Barient # 17 self tailing winches on coach roof - Three Barient # 18 winches on mast.

Electronics and electrical - 

ICOM M80 VHF - GARMIN 3205 GPS MAP - Autohelm 6000 AP Autopilot - Datamarine digital depth sounder - Digital speed - distance log - 5" Ritchie compass

Sony AM/FM with CD player - Sony speakers

30 Amp shore power inlet and cord

PEAK 1200 Watt inverter

Raritan charger

Five gel cell batterys

60 Amp alternator

ENGINE

Universal 50 HP 4 cylinder FWC diesel with approximately 4,200 hours -  2 : 1 reduction -  Raw water sea strainer - Water lift muffler system - Halon automatic fire suppression - 3 Blade prop -

Two 50 gallon fuel tanks - Each tank has its own dedicated Dahl fuel filter and fuel pump.

Maintained to the highest standards - Runs perfectly with nothing needed.

Engine controls are on the binnacle - Instrument panel is located on the forward bulkhead of the cockpit

This yacht was constructed by Liberty Yachts in Riverira Beach, Florida - ONLY SIX WERE MADE - SUN JOY IS HULL # 4.

Hull and deck construction is 100% hand laid fiberglass with integral sheer flange for a strong, watertight hull / deck joint. The connection has mated hull and deck flanges bedded in 3M 5200 and through bolted on 4" centers with stainless bolts

The decks are 100% hand laminated with 3/4 inch thick high density closed cell - non absorbent core. There is solid fiberglass in the areas where hardware is through bolted

Bulkheads are marine grade plywood with Airex fillet and fiberglassed to hull on both sides

Pulpit with double anchor rollers - 35 lb CQR with 250' of chain - 35 lb Bruce anchor with 30' of chain and 200' nylon rode - Danforth spare anchor - Divided anchor locker

Simpson Lawrence manual windlass

Outboard engine hoist

Simply put - You could not dream of a more distinctly - heavily built - beautifully maintained bluewater cruiser - Sea Joy has it all - You could not ask for more or better.

Thank you.

 

 

 

 

 

 

 

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.



Features:

TypeSail

CategoryCruisers

Sloop

MakeLiberty Pacific Seacraft

ModelCutter Rigged Canoe Stern

Year built1986

Length37.99ft

Hull MaterialFibreglass

Beam11.52ft

Draft4.99ft

Type keel:Full keel

New/UsedUsed

FuelDiesel