Pascoe Sr9 European Inboard - Price just reduced

This 2004 Pascoe SR9 European Inboard RIB has a stepped hull which was designed by Ocke Mannefelt (the winner of over 10 World and National Championships). The stepped hull is moulded in lightweight Kevlar/aramid composite construction with Divinycell longitudunal stiffening, isopthalic resin and gelcoat system.

This SR9 is powered by a single Yanmar 315 hp Diesel inboard which was replaced in 2008, detailed and repainted in 2011. Being run on a Mercury Bravo One X drive with 1.50 ratio, the gimbles and transom shield were replaced in 2011 and is run with a 28 inch stainless steel Bravo One propeller.

Her console is setup with two racing bucket seats and two jockey seats behind, she benefits from have duel foot and hand throttle controls.

She is ready for the season and comes complete with twin axle road trailer which was recently serviced.

Owners Comments:

I have just had the whole hull flat & polish so now looks like new & any gel coat chips repaired. Cruise speed is 50mph. She will sit at that speed all day with no issues & a smooth ride. Fuel consumption is very good, if I remember correctly full speed approx 60mph its a litre a mile.

• Ocke Mannefelt stepped hull - Lightweight Kevlar/Aramid vinylester moulded construction
• Heave duty two-tone Hypalon tubes
• Full length rubbing strakes
• Bow ballast tank

Features: